Editando Comandos Básicos Cisco

==Comandos Básicos de Cisco==

Configurando um nome

 Switch>enable
 Switch#configure terminal
 Switch(config)#hostname sw01vkn8
 sw01vkn8#

Configurando senha enable
 Switch>enable
 Switch#configure terminal
 Switch(config)#enable password cisco

Configurando senha enable secret
 Router>enable
 Router#configure terminal
 Router(config)#enable secret cisco@10
 
Configurando senha da console
 Router>enable
 Router#configure terminal
 Router(config)#line console 0
 Router(config-line)#password cisco@123
 
Configurando acesso telnet para 05 usuários
 Switch>enable
 Switch#configure terminal
 Switch(config)#line vty 0 4
 Switch(config-line)#login
 Switch(config-line)#password cisco@123

Configurando o endereço IP do switch
 Switch>enable
 Switch#configure terminal
 Switch(config)#interface vlan 1
 Switch(config-if)#ip address 10.0.10.1 255.255.255.0
 Switch(config-if)#no shutdown

Configurando o gateway do switch

 Switch>enable
 Switch#configure terminal
 Switch(config)#ip default-gateway 10.0.10.1         

Configurando vlan no switch

 Switch>enable
 Switch#configure terminal
 Switch(config)#vlan 10
 Switch(config-vlan)#name dep-administrativo
 Switch(config-vlan)#exit
 Switch(config)#
 
 Switch(config)#interface fastEthernet 0/1
 Switch(config-if)#switchport mode access
 Switch(config-if)#switchport access vlan 10
 Switch(config-if)#exit
 Switch(config)#exit
 Switch#sh vlan
 
Configurando trunk no switch

 Switch>enable
 Switch#configure terminal
 Switch(config)#interface fastEthernet 0/1
 Switch(config-if)#switchport mode trunk